VERAPAMIL HCI

INDICATIONS & USAGE Verapamil Hydrochloride Injection, USP is indicated for the following: • Rapid conversion to sinus rhythm of paroxysmal supraventricular tachycardias, including those associated with accessory bypass tracts (Wolff-Parkinson-White [W-P-W] and Lown-Ganong- Levine [L-G-L] syndromes). When clinically advisable, appropriate vagal maneuvers (e.g., Valsalva maneuver) should be attempted prior to verapamil hydrochloride administration. • Temporary control of rapid ventricular rate in atrial flutter or atrial fibrillation except when the atrial flutter and/or atrial fibrillation are associated with accessory bypass tracts (Wolff-Parkinson-White (W-P-W) and Lown-Ganong-Levine (L-G-L) syndromes). In controlled studies in the United States, about 60% of patients with supraventricular tachycardia converted to normal sinus rhythm within 10 minutes after intravenous verapamil hydrochloride. Uncontrolled studies reported in the world literature describe a conversion rate of about 80%. About 70% of patients with atrial flutter and/or fibrillation with a faster ventricular rate respond with a decrease in ventricular rate of at least 20%. Conversion of atrial flutter or fibrillation to sinus rhythm is uncommon (about 10%) after verapamil hydrochloride and may reflect the spontaneous conversion rate, since the conversion rate after placebo was similar. Slowing of the ventricular rate in patients with atrial fibrillation/flutter lasts 30 to 60 minutes after a single injection. Because a small fraction (<1%) of patients treated with verapamil hydrochloride respond with life-threatening adverse responses (rapid ventricular rate in atrial flutter/fibrillation, and an accessory bypass tract, marked hypotension, or extreme bradycardia/asystole − see CONTRAINDICATIONS and WARNINGS), the initial use of verapamil hydrochloride injection should, if possible, be in a treatment setting with monitoring and resuscitation facilities, including D.C.-cardioversion capability (see ADVERSE REACTIONS, Suggested Treatment of Acute Cardiovascular Adverse Reactions). As familiarity with the patient's response is gained, use in an office setting may be acceptable. Cardioversion has been used safely and effectively after verapamil hydrochloride injection.

DOSAGE AND ADMINISTRATION (FOR INTRAVENOUS USE ONLY). VERAPAMIL HYDROCHLORIDE INJECTION SHOULD BE GIVEN AS A SLOW INTRAVENOUS INJECTION OVER AT LEAST A TWO-MINUTE PERIOD OF TIME UNDER CONTINUOUS ELECTROCARDIOGRAPHIC (ECG) AND BLOOD PRESSURE MONITORING. The recommended intravenous doses of verapamil hydrochloride injection are as follows: Adult: Initial dose - 5 to 10 mg (0.075 to 0.15 mg/kg body weight) given as an intravenous bolus over at least 2 minutes. Repeat dose - 10 mg (0.15 mg/kg body weight) 30 minutes after the first dose if the initial response is not adequate. An optimal interval for subsequent intravenous doses has not been determined, and should be individualized for each patient. Older patients - The dose should be administered over at least 3 minutes to minimize the risk of untoward drug effects. Pediatric: Initial dose: 0 to 1 year: 0.1 to 0.2 mg/kg body weight (usual single-dose range: 0.75 to 2 mg) should be administered as an intravenous bolus over at least 2 minutes under continuous ECG monitoring. 1 to 15 years: 0.1 to 0.3 mg/kg body weight (usual single-dose range: 2 to 5 mg) should be administered as an intravenous bolus over at least 2 minutes. Do not exceed 5 mg. Repeat dose: 0 to 1 year: 0.1 to 0.2 mg/kg body weight (usual single-dose range: 0.75 to 2 mg) 30 minutes after the first dose if the initial response is not adequate (under continuous ECG monitoring). An optimal interval for subsequent intravenous doses has not been determined, and should be individualized for each patient. 1 to 15 years: 0.1 to 0.3 mg/kg body weight (usual single-dose range: 2 to 5 mg) 30 minutes after the first dose if the initial response is not adequate. Do not exceed 10 mg as a single-dose. An optimal interval for subsequent intravenous doses has not been determined, and should be individualized for each patient. Note: Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. Use only if solution is clear and vial seal is intact. Unused amount of solution should be discarded immediately following withdrawal of any portion of contents. For stability reasons this product is not recommended for dilution with Sodium Lactate Injection, USP in polyvinyl chloride bags. Verapamil hydrochloride is physically compatible and chemically stable for at least 24 hours at 25°C protected from light in most common large volume parenteral solutions. Admixing verapamil hydrochloride injection with albumin, amphotericin B, hydralazine hydrochloride and trimethoprim with sulfamethoxazole should be avoided. Verapamil hydrochloride injection will precipitate in any solution with a pH above 6.0.

CONTRAINDICATIONS Verapamil hydrochloride injection is contraindicated in: Severe hypotension or cardiogenic shock. Second-or third-degree AV block (except in patients with a functioning artificial ventricular pacemaker). Sick sinus syndrome (except in patients with a functioning artificial ventricular pacemaker). Severe congestive heart failure (unless secondary to a supraventricular tachycardia amenable to verapamil hydrochloride therapy). Patients receiving intravenous beta-adrenergic blocking drugs (e.g., propranolol). Intravenous verapamil hydrochloride and intravenous beta-adrenergic blocking drugs should not be administered in close proximity to each other (within a few hours), since both may have a depressant effect on myocardial contractility and AV conduction. Patients with atrial flutter or atrial fibrillation and an accessory bypass tract (e.g., Wolff- Parkinson-White, Lown-Ganong-Levine syndromes) are at risk to develop ventricular tachyarrhythmia including ventricular fibrillation if verapamil hydrochloride is administered. Therefore, the use of verapamil hydrochloride in these patients is contraindicated. Ventricular tachycardia: Administration of intravenous verapamil hydrochloride to patients with wide-complex ventricular-tachycardia (QRS ≥ 0.12 sec) can result in marked hemodynamic deterioration and ventricular fibrillation. Proper pre-therapy diagnosis and differentiation from wide-complex supraventricular tachycardia is imperative in the emergency room setting. Known hypersensitivity to verapamil hydrochloride.

ADVERSE REACTIONS The following reactions were reported with verapamil hydrochloride injection used in controlled U.S. clinical trials involving 324 patients: Cardiovascular: Symptomatic hypotension (1.5%); bradycardia (1.2%); severe tachycardia (1.0%). The worldwide experience in open clinical trials in more than 7,900 patients was similar. Central Nervous System Effects: Dizziness (1.2%); headache (1.2%). Occasional cases of seizures during verapamil hydrochloride injection have been reported. Gastrointestinal: Nausea (0.9%); abdominal discomfort (0.6%). In rare cases of hypersensitive patients, broncho/laryngeal spasm accompanied by itch and urticaria have been reported. The following reactions have been reported at low frequency: emotional depression, rotary nystagmus, sleepiness, vertigo, muscle fatigue, diaphoresis, and respiratory failure. Suggested Treatment of Acute Cardiovascular Adverse Reactions* The frequency of these adverse reactions was quite low, and experience with their treatment has been limited. To report SUSPECTED ADVERSE REACTIONS, contact AuroMedics Pharma LLC at 1-866-850-2876 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch. ADVERSE

DESCRIPTION Verapamil hydrochloride is a calcium antagonist or slow-channel inhibitor. Verapamil Hydrochloride Injection, USP is a sterile, nonpyrogenic solution containing verapamil hydrochloride 2.5 mg/mL and sodium chloride 8.5 mg/mL in water for injection. The solution contains no bacteriostat or antimicrobial agent and is intended for single-dose intravenous administration. May contain hydrochloric acid for pH adjustment; pH is 4.0 to 6.5. The chemical name of Verapamil Hydrochloride, USP is benzeneacetonitrile, α-[3-[{2-(3,4-dimethoxyphenyl)ethyl} methylamino] propyl]-3,4-dimethoxy-α-(1-methylethyl) hydrochloride. Verapamil hydrochloride is a white or practically white crystalline powder. It is practically odorless and has a bitter taste. It is soluble in water; freely soluble in chloroform; sparingly soluble in alcohol; practically insoluble in ether. It has the following structural formula: Molecular weight: 491.07 Molecular formula: C27H38N2O4 • HCl Verapamil hydrochloride is not chemically related to other antiarrhythmic drugs. The plastic syringe is molded from a specially formulated polypropylene. Water permeates from inside the container at an extremely slow rate which will have an insignificant effect on solution concentration over the expected shelf life. Solutions in contact with the plastic container may leach out certain chemical components from the plastic in very small amounts; however, biological testing was supportive of the safety of the syringe material. STRUCTURE

OVERDOSAGE Treatment of overdosage should be supportive and individualized. Beta-adrenergic stimulation and/or parenteral administration of calcium solutions may increase calcium ion flux across the slow channel, and have been effectively used in treatment of deliberate overdosage with oral verapamil hydrochloride. Verapamil hydrochloride cannot be removed by hemodialysis. Clinically significant hypotensive reactions or high-degree AV block should be treated with vasopressor agents or cardiac pacing, respectively. Asystole should be handled by the usual measures including isoproterenol hydrochloride, other vasopressor agents, or cardiopulmonary resuscitation (See ADVERSE REACTIONS : SUGGESTED TREATMENT OF ACUTE CARDIOVASCULAR ADVERSE REACTIONS.)

HOW SUPPLIED Verapamil Hydrochloride Injection, USP is a sterile, clear colorless solution and is supplied in single-dose containers: NDC 51662-1548-1 HF Acquisition Co LLC, DBA HealthFirst Mukilteo, WA 98275 Also supplied in the following manufacture supplied dosage forms: Verapamil Hydrochloride Injection, USP is a sterile, clear colorless solution and is supplied in single-dose containers as follows: 5 mg per 2 mL (2.5 mg/mL) 2 mL Single-Dose Vial NDC 55150-342-01 1-unit pack carton 2 mL Single-Dose Vials NDC 55150-342-05 5 pack carton 2 mL Single-Dose Vials 25-unit pack carton NDC 55150-342-25 10 mg per 4 mL (2.5 mg/mL) 4 mL Single-Dose Vial NDC 55150-343-01 1-unit pack carton 4 mL Single-Dose Vials NDC 55150-343-05 5 pack carton 4 mL Single-Dose Vials 25-unit pack carton NDC 55150-343-25 Store at 20° to 25°C (68° to 77°F) [see USP Controlled Room Temperature]. Protect from light by retaining in carton until ready to use. The vial stopper is not made with natural rubber latex. Distributed by: AuroMedics Pharma LLC 279 Princeton-Hightstown Rd. E. Windsor, NJ 08520 Manufactured by: Eugia Pharma Specialities Limited Hyderabad - 500032 India Revised: October 2021