Milrinone Lactate in 5% Dextrose

INDICATIONS AND USAGE Milrinone is indicated for the short-term intravenous treatment of patients with acute decompensated heart failure. Patients receiving milrinone should be observed closely with appropriate electrocardiographic equipment. The facility for immediate treatment of potential cardiac events, which may include life threatening ventricular arrhythmias, must be available. The majority of experience with intravenous milrinone has been in patients receiving digoxin and diuretics. There is no experience in controlled trials with infusions of milrinone for periods exceeding 48 hours.

DOSAGE AND ADMINISTRATION Milrinone Lactate in 5% Dextrose Injection should be administered with a loading dose followed by a continuous infusion (maintenance dose) according to the following guidelines: Loading Dose 50 mcg/kg: Administer slowly over 10 minutes Note: Milrinone (200 mcg per mL) in Plastic Container is for intravenous infusion only. Dosage recommendations using a 1 mg per mL concentration of milrinone are included for informational purposes only. The table below shows the loading dose in milliliters (mL) of milrinone (1 mg/mL) by patient body weight (kg). Loading Dose (mL) Using 1 mg/mL Concentration Patient Body Weight (kg) kg 30 40 50 60 70 80 90 100 110 120 mL 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0 The loading dose may be given undiluted, but diluting to a rounded total volume of 10 or 20 mL (see Maintenance Dose for diluents) may simplify the visualization of the injection rate. Maintenance Dose Infusion Rate Total Daily Dose (24 Hours) Minimum Standard Maximum 0.375 mcg/kg/min 0.50 mcg/kg/min 0.75 mcg/kg/min 0.59 mg/kg 0.77 mg/kg 1.13 mg/kg Administer as a continuous intravenous infusion The infusion rate should be adjusted according to hemodynamic and clinical response. Patients should be closely monitored. In controlled clinical studies, most patients showed an improvement in hemodynamic status as evidenced by increases in cardiac output and reductions in pulmonary capillary wedge pressure. Note: See “Dosage Adjustment in Renally Impaired Patients.” Dosage may be titrated to the maximum hemodynamic effect and should not exceed 1.13 mg/kg/day. Duration of therapy should depend upon patient responsiveness. The maintenance dose in mL/hr by patient body weight (kg) may be determined by reference to the following table. Milrinone Infusion Rate (mL/hr) Using 200 mcg/mL Concentration Maintenance Dose (mcg/kg/min) Patient Body Weight (kg) 30 40 50 60 70 80 90 100 110 120 0.375 3.4 4.5 5.6 6.8 7.9 9.0 10.1 11.3 12.4 13.5 0.400 3.6 4.8 6.0 7.2 8.4 9.6 10.8 12.0 13.2 14.4 0.500 4.5 6.0 7.5 9.0 10.5 12.0 13.5 15.0 16.5 18.0 0.600 5.4 7.2 9.0 10.8 12.6 14.4 16.2 18.0 19.8 21.6 0.700 6.3 8.4 10.5 12.6 14.7 16.8 18.9 21.0 23.1 25.2 0.750 6.8 9.0 11.3 13.5 15.8 18.0 20.3 22.5 24.8 27.0 Dosage Adjustment in Renally Impaired Patients Data obtained from patients with severe renal impairment (creatinine clearance = 0 to 30 mL/min) but without congestive heart failure have demonstrated that the presence of renal impairment significantly increases the terminal elimination half-life of milrinone. Reductions in infusion rate may be necessary in patients with renal impairment. For patients with clinical evidence of renal impairment, the recommended infusion rate can be obtained from the following table: Creatinine Clearance (mL/min/1.73m 2 ) Infusion Rate (mcg/kg/min) 5 0.20 10 0.23 20 0.28 30 0.33 40 0.38 50 0.43 Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. Milrinone Lactate in 5% Dextrose Injection is a clear, colorless to pale yellow solution. DIRECTIONS FOR USE When administering Milrinone Lactate in 5% Dextrose Injection by continuous infusion, it is advisable to use a calibrated electronic infusion device. To open Tear at the notch and open the overwrap to remove solution container. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed. This is normal and does not affect the solution quality or safety. The opacity will diminish gradually. After removing overwrap, check for minute leaks by squeezing inner bag firmly. If leaks are found, discard solution as sterility may be impaired. Preparation for Administration Visually inspect the container. If the administration port is damaged, detached, or not present, discard container as solution path sterility may be impaired. (Use aseptic technique) 1. Suspend container from eyelet support. 2. Remove top portion of twi …

CONTRAINDICATIONS Milrinone is contraindicated in patients who are hypersensitive to it. Solutions containing dextrose may be contraindicated in patients with known allergy to corn or corn products.

ADVERSE REACTIONS Cardiovascular Effects In patients receiving milrinone in Phase II and III clinical trials, ventricular arrhythmias were reported in 12.1%: Ventricular ectopic activity, 8.5%; nonsustained ventricular tachycardia, 2.8%; sustained ventricular tachycardia, 1% and ventricular fibrillation, 0.2% (2 patients experienced more than one type of arrhythmia). Holter recordings demonstrated that in some patients injection of milrinone increased ventricular ectopy, including nonsustained ventricular tachycardia. Life-threatening arrhythmias were infrequent and when present have been associated with certain underlying factors such as preexisting arrhythmias, metabolic abnormalities (e.g. hypokalemia), abnormal digoxin levels and catheter insertion. Milrinone was not shown to be arrhythmogenic in an electrophysiology study. Supraventricular arrhythmias were reported in 3.8% of the patients receiving milrinone. The incidence of both supraventricular and ventricular arrhythmias has not been related to the dose or plasma milrinone concentration. Other cardiovascular adverse reactions include hypotension, 2.9% and angina/chest pain, 1.2%. In the post marketing experience, there have been rare cases of “torsades de pointes” reported. CNS Effects Headaches, usually mild to moderate in severity, have been reported in 2.9% of patients receiving milrinone. Other Effects Other adverse reactions reported, but not definitely related to the administration of milrinone include hypokalemia, 0.6%; tremor, 0.4%; and thrombocytopenia, 0.4%. Post-Marketing Adverse Event Reports In addition to adverse events reported from clinical trials, the following events have been reported from worldwide post-marketing experience with Milrinone: Isolated spontaneous reports of bronchospasm and anaphylactic shock. Liver function test abnormalities and skin reactions such as rash. Administration site conditions: Infusion site reaction.

Drug Interactions No untoward clinical manifestations have been observed in limited experience with patients in whom milrinone was used concurrently with the following drugs: digitalis glycosides; lidocaine, quinidine; hydralazine, prazosin; isosorbide dinitrate, nitroglycerin; chlorthalidone, furosemide, hydrochlorothiazide, spironolactone; captopril; heparin, warfarin, diazepam, insulin; and potassium supplements.

DESCRIPTION Milrinone lactate is a member of a new class of bipyridine inotropic/vasodilator agents with phosphodiesterase inhibitor activity, distinct from digitalis glycosides or catecholamines. Milrinone lactate is designated chemically as 1,6- dihydro-2-methyl-6-oxo-[3,4’-bipyridine]-5-carbonitrile lactate and has the following structure: Milrinone, USP is a white to tan crystalline compound with a molecular weight of 211.2 and a molecular formula of C 12 H 9 N 3 O. It is freely soluble in dimethyl sulfoxide; very slightly soluble in methanol, practically insoluble in water and in chloroform. As the lactate salt, it is stable and colorless to pale yellow in solution. Milrinone is available as sterile aqueous solutions of the lactate salt of milrinone for infusion intravenously. The Flexible containers provide two ready-to-use dilutions of milrinone in volumes of 100 mL and 200 mL of 5% Dextrose Injection. Each mL contains milrinone lactate equivalent to 200 mcg milrinone. The nominal concentration of lactic acid is 0.282 mg/mL. Each mL also contains 54.3 mg dextrose, hydrous, USP. The pH is adjusted to between 3.2 and 4.0 with lactic acid and/or sodium hydroxide. The flexible plastic container is comprised of polypropylene with a foil overwrap. Water can permeate the plastic into the overwrap, but the amount is insufficient to significantly affect the premixed solution. milrinone-structure

OVERDOSAGE Doses of milrinone may produce hypotension because of its vasodilator effect. If this occurs, administration of milrinone should be reduced or temporarily discontinued until the patient’s condition stabilizes. No specific antidote is known, but general measures for circulatory support should be taken.

HOW SUPPLIED Milrinone Lactate in 5% Dextrose Injection is a clear, colorless to pale yellow solution and is supplied in Infusion bags as follows: NDC No. Milrinone Lactate in 5% Dextrose Injection (200 mcg (0.2 mg) per mL) Pack Style 65145-176-01 20 mg per 100 mL Single-Dose Infusion bag 1 Single-dose Infusion Bag in an Overwrap 65145-177-01 40 mg per 200 mL Single-Dose Infusion bag 1 Single-dose Infusion Bag in an Overwrap Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. Protect from freezing. It is recommended that the Flexible Containers be stored at room temperature, 25°C (77°F), however, brief exposure up to 40°C (104°F) does not adversely affect the product. Discard unused portion. Made in India Distributed By : Caplin Steriles USA Inc, Hamilton, NJ 08619. Code: TN/Drugs/TN00003462 Code: TN/Drugs/TN00006405 July, 2025 22201142 milrinone-caplin-logo